Table of Contents
Advertisement
Wall Switch Wire for Separate
Control of Light Fixture
Power
Black
Wires
in
White
Ceiling
Bare or Green
2 x 4 Brace
Approved
Connectors
Green Ground Wire from
Hanger Pipe (not present
with flush mounting
option)
F F F F F i i i i i g g g g g ur ur ur ur ure 19 - W
e 19 - Wir ir ir ir irin in in in ing t
e 19 - W
e 19 - W
e 19 - W
installing the canopy
1.
Rotate the fan 180º clockwise from the initial position when
hanging the fan. The arrows on the hanger ball and on the
ceiling plate should be pointing in the same direction and
should be pointing towards the tab hole on the canopy. Refer
to Figure 20.
F F F F F i i i i i g g g g g ur ur ur ur ure 20 - R
e 20 - R
e 20 - R
e 20 - Ro o o o o t t t t t a a a a a t t t t t in in in in ing t
e 20 - R
For Flush Mounting: The arrows on the low profile washer and
on the ceiling plate should be pointing in the same direction
and should be pointing towards the tab hole on the canopy.
2.
Hook the tab hole over the tab on the ceiling plate as shown in
Figure 21.
3.
Raise the canopy, be sure the holes in the canopy and the ceil-
ing plate are aligned, and loosely assemble the canopy screws
one at a time. When all three screws are assembled, securely
tighten all three canopy screws. Refer to Figure 21.
© 2003 Hunter Fan Company
(Note: Wall
switch must be
acceptable as a
general-use
switch.)
Outlet Box
Ceiling Plate
Connections:
1
1. Connect Blk/Wht
2
wire from the fan to the
wall switch for separate
Blk/Wht
control of the light
3 Wires
fixture, or
from Fan
2. Connect Blk/Wht
wire from the fan to the
ceiling black wire if there
is no separate wall
switch wire for the light
fixture.
g th h h h h e f e f e f e f e fa a a a a n n n n n
g t
g t
g t
g t g t
g t
g th h h h h e f e f e f e f e fa a a a a n n n n n
Tab Hole
and Tab
Canopy
Screw
F F F F F i i i i i g g g g g ur ur ur ur ure 21 - I
e 21 - I
e 21 - I
e 21 - In n n n n s s s s s t t t t t a a a a a llin
e 21 - I
installing the canopy trim ring
1.
To easily install the canopy trim ring, locate the two tabs on
the canopy trim ring. See Figure 22.
Press Here when
Removing
Canopy
Trim Ring
F F F F F i i i i i g g g g g ur ur ur ur ure 22 - C
e 22 - C
e 22 - Ca a a a a n n n n n o o o o o p p p p p y t
e 22 - C
e 22 - C
2.
Take both hands and push the canopy trim ring up to the top
of the canopy. See Figure 22.
3.
The canopy trim ring will snap and lock into place on the
canopy.
removing the canopy trim ring
1.
Locate the tab indicators, small bumps on top of tabs. Refer to
Figure 23.
2.
To remove the canopy trim ring, press firmly on opposite sides
of the ring towards the canopy as shown in Figure 23. The tabs
will flex out releasing the trim ring from the canopy.
Tab Indicator
Canopy
F F F F F i i i i i g g g g g ur ur ur ur ure 23 - R
e 23 - R
e 23 - R
e 23 - R
e 23 - Re e e e e m m m m m o o o o o v v v v v in in in in ing t
llin
llin
g t g t
g t
g th h h h h e c
e ca a a a a n n n n n o o o o o p p p p p y y y y y
e c
e c
lling t
llin
e c
Canopy
Press Here when
Removing
Tab
y tr r r r r im r
y t
y t y t
im r
im rin in in in ing g g g g
im r
im r
Canopy Trim Ring
g t
g t g t
g th h h h h e c
e c
e c
e c
e ca a a a a n n n n n o o o o o p p p p p y t
y tr r r r r im r
y t
y t y t
im r
im r
im rin in in in ing g g g g
im r
41835-01 04/30/2003
7 7 7 7 7
Advertisement
Table of Contents
