8
124
Clamp of quick-release
axle
Tightening sequence: Tighten
z
screws six times in alternate
sequence
19 Nm
Removing rear wheel
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
OE
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove screw 1 and remove
the pulse sensor from its bore.
Remove axle nut 2.
Slacken locknuts 3 on left and
right by turning them counter-
clockwise.
Back off adjusting screws 4 on
left and right by turning them
counter-clockwise.
Remove adjusting plate 5 and
push the axle in as far as it will
go.