Select A Chart Source - Humminbird HELIX 9 Operation Manual

S C S
ELECT A HART
The HELIX control head includes a built-in Contour XD chart (domestic models) or UniMap (international models). You can also
install SD map cards with additional chart information for a particular location (separate purchase required).
When you install an SD map card, the control head automatically chooses the best map to display. If you install more than one SD
map card, you can choose which chart source you want to use.
Install an SD Map Card
1. Remove the SD card slot cover.
2. Position the SD map card so that the label faces to the left.
3. Insert the card into the slot until it clicks into place.
4. Replace the slot cover so it is secure.
5. Remove: Press the card into the slot and release it. The card will eject. Pull the card
carefully from the slot.
NOTE: Do not leave the SD card slot cover open. The slot cover should always be closed to
prevent water damage to the unit.
Change the Chart Source
When you install an SD map card, the chart source is changed automatically to match the SD map card chart source. You can also
change the chart source manually.
When you change the chart source, the menus for the chart views also change, allowing you to add navigation data, shading, alarms,
and more.
1. Main Menu: Press the MENU key twice. Select the Chart tab.
2. Select Chart Select.
3. Select the installed map card location or a built-in map.
Auto: The best available chart will be selected automatically.
Chart Overview
OURCE
92
Insert the SD map card with the
label facing to the left