Steering Alignment; Central Body - BRP SPARK SERIES Operator's Manual

NOTE: A cooling system that fre-
quently requires coolant is an indica-
tion of leaks or engine problems. See
an authorized Sea-Doo dealer.
Engine Coolant Replacement
Coolant replacement should be per-
formed by an authorized Sea-Doo
dealer.

Steering Alignment

1. Manually release and remove the
LH side knee pad.
NOTE: This area is intended only to ac-
cess the steering cable assembly. Do
not use this area for storage purposes.
smo2014-005-032_a
1. LH Side knee pad
2. Unclip the steering cable by pushing
the ring up towards the nut.
smo2014-005-033_a
STEERING CABLE UNCLIPPED
1. Ring
2. Nut
3. Put the jet pump nozzle in straight
position.
4. Unscrew nut to turn handlebar to
the right.
5. Screw nut to turn handlebar to the
left.
6. When steering alignment is com-
plete, clip the steering cable by
pushing the ring back down and re-
installing the LH side knee pad.

Central Body

Central Body Removal
When necessary, remove the central
body as follows:
Never attempt to lift the central
body alone. Lift only with assis-
tance or use an appropriate lifting
device. Lifting alone can cause se-
rious injury.
1. Turn the LH access cover knob 1/4
turn clockwise, then pull out to un-
snap the rear portion and slide rear-
ward to remove.
smo2015-005-005_a
LH ACCESS COVER
1. To unlock, turn the knob 1/4 turn clockwise
2. Disconnect the steering connector.
_______________
MAINTENANCE PROCEDURES
WARNING
83