Onkyo TX-SR444 Basic Manual page 57

RI Dock
● Make sure the unit is turned on, the correct input source
is selected, and the volume is turned up.
● Make sure the plugs are pushed in all the way.
● Make sure your iPod/iPhone is properly inserted in
the Dock. If your iPod/iPhone is in a case, it may not
connect properly to the Dock. Always remove your iPod/
iPhone from the case before inserting it into the Dock.
Try reconnecting your iPod/iPhone.
● Make sure your iPod/iPhone is actually playing.
Check the following if the above does not fix the problem:
 There is no sound
¼
● Try resetting your iPod/iPhone.
 There is no video
¼
● Make sure the correct input is selected on your TV or
the unit.
● Make sure that your iPod/iPhone model's TV OUT
setting is set to On.
● Some versions of the iPod/iPhone do not output video.
 The AV receiver's remote controller does not control
¼
your iPod/iPhone
● The iPod/iPhone cannot be operated while it is
displaying the Apple logo.
● Make sure you have selected the correct remote
controller mode.
● When you use the AV receiver's remote controller, point
it toward this unit.
● Before operating with the remote controller, you may
need to play on your iPod/iPhone to make the input
selector be recognized.
● Depending on your iPod/iPhone model and generation,
some buttons may not work as expected.
● Try resetting your iPod/iPhone.
 The unit unexpectedly selects your iPod/iPhone as
¼
the input source
● Always pause iPod/iPhone playback before selecting
a different input source. If playback is not paused, the
Direct Change function may select your iPod/iPhone
as the input source by mistake during the transition
between tracks.
Others
 Strange noises can be heard from the unit
¼
● If you have connected another unit to the same wall
outlet as this unit, this noise may be an effect from the
other unit. If the symptoms improve by unplugging the
power cord of the other unit, use different wall outlets for
this unit and the other unit.
 When performing Automatic Speaker Setup, the
¼
measurement fails and the message "Ambient noise is
too high�" is displayed
● This can be caused by a malfunction in your speaker
unit. Check if the unit produces normal sounds.
 The Late Night function does not work
¼
● Make sure the source material is Dolby Digital, Dolby
Digital Plus or Dolby TrueHD.
 The Cinema Filter function does not work
¼
● This function can be used in the following listening
modes: Dolby Digital, Dolby Digital Plus, Dolby TrueHD,
Multichannel, DSD, DTS, DTS-ES, DTS Neo:6 Cinema,
DTS 96/24, DTS-HD High Resolution Audio, DTS-HD
Master Audio, DTS Express.
 How do I change the language of a multiplex source
¼
● Select "Main" or "Sub" for "Multiplex Input Channel" in
"3. Audio Adjust" -"Multiplex/Mono".
 Power consumption in standby mode
¼
● In the following cases, the power consumption in
standby mode may reach up to a maximum of 33 W:
– When "HDMI CEC (RIHD)" is set to "On". (Depending
on the TV status, the AV receiver will enter normal
standby mode.)
– The "HDMI Standby Through" setting is set to other
than "Off".
– The "Power Out at Standby for STRM BOX" setting
is "On".
Troubleshooting
En-37