Installation Instructions; Tools And Parts; Custom Panel Dimensions - Jenn-Air W10520236E Use & Care Manual

Tools and Parts

Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
Phillips screwdriver
Router or planer
Pencil
Parts Needed
Custom Overlay Door Panel—See "Custom Panel Dimensions,"
#8 x ¹⁄₂" pan-head wood screws (8)
Parts Supplied
Adhesive pads (4)

Custom Panel Dimensions

If you plan to install a custom overlay panel, you will need to
make the panel yourself or consult a qualified cabinetmaker or
carpenter.
IMPORTANT:
The thickness of the overlay panel must be ³⁄₄" (1.91 cm).
Overlay panel must not weigh more than 8 lbs (3.62 kg).
Overlay panels weighing more than recommended may
cause damage to your ice maker.
Match wood grain direction with that of adjacent cabinets.
Sand panel edges to provide a smooth finish.
Use moisture sealer on both sides and all edges of the panel
to avoid damage from moisture.
Option 1—Without Hinge-Side Spacer
To allow proper clearance for the door, prepare the custom
overlay panel using the dimensions shown.
4

INSTALLATION INSTRUCTIONS

Masking tape
Tape measure
Towel or piece of cardboard
30³⁄₁₆
(76.6 cm)
⁄₃₂
14¹⁷ "
(36.9 cm)
1¹⁄₄
(3.18 cm)
¹⁄₄
"
(6.35 mm)
Option 2—With Hinge-Side Spacer
To achieve a flush installation with adjacent cabinets, prepare the
custom overlay panel using the dimensions shown.
Front of Panel
Top of Panel
A. Front—visible surface when installed
B. Hinge side
"
Bottom of Panel
A. Front—visible surface when installed
B. Hinge side
NOTE: Compare overlay panel dimensions to the adjacent
cabinetry, and adjust the height of the custom panel accordingly.
"
³⁄₄ ³⁄₄
" "
(1.91 cm) (1.91 cm)
⁵⁄₈
14 "
(37.1 cm)
A
A
1¹⁄₄
"
(3.18 cm)
¹⁄₄
"
(6.35 mm)
30³⁄₁₆
"
(76.6 cm)
B
B