Ice Maker Safety; Installation Instructions; Tools And Parts; Custom Panel Dimensions - Jenn-Air ICE MAKER Use & Care Manual

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
WARNING
: To reduce the risk of fire, electric shock, or injury when using your ice maker, follow these basic
precautions :
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.

Tools and Parts

TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Cordless drill
Phillips screwdriver
Router or planer
Pencil
PARTS NEEDED:
Custom Overlay Door Panel—See "Custom Panel Installation
Instructions," #8 x " pan head wood screws (8)
PARTS SUPPLIED:
Adhesive pads (4)

ICE MAKER SAFETY

Your safety and the safety of others are very important.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Masking tape
Tape measure
Towel or piece of
cardboard
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Disconnect power before cleaning.
Disconnect power before servicing.
Replace all parts and panels before operating.
Use two or more people to move and install ice maker.

Custom Panel Dimensions

If you plan to install a custom overlay panel, you will need to
create the panel yourself or consult a qualified cabinetmaker or
carpenter.
IMPORTANT:
The thickness of the overlay panel must be
Overlay panel must not weigh more than 8 lbs (3.62 kg).
Overlay panels weighing more than recommended may
cause damage to your ice maker.
Match woodgrain direction with that of adjacent cabinets.
Sand panel edges to provide a smooth finish.
Use moisture sealer on both sides and all edges of the
panel to provide moisture protection.
" (1.91 cm).
3