Table of Contents
Advertisement
The TEST key puts your system into the Test mode, which allows each protection point to be
Using the
5
checked for proper operation. The keypad sounds a single beep every 40 seconds as a
TEST Key
reminder that the system is in the Test mode.
Note:
1.
2.
(Security Code)
3. LISTEN.
4. FAULT ZONES.
TESTING THE SYSTEM
(TO BE CONDUCTED WEEKLY)
An alarm message will not be sent to be sent to your alarm monitoring company during
the following tests.
DISARM THE SYSTEM
DISARME D
Disarm the system and close all protected windows, doors, etc.
RE ADY T O ARM
The "Ready" message should be displayed and the green
READY indicator should also be lit .
TEST
+
5
ENTER THE SECURITY CODE THEN PRESS TEST
Example:
The external sounder should sound for 1 second and then turn
off.
If the sounder does not sound, CALL FOR SERVICE
IMMEDIATELY.
Open each protected door and window in turn and listen for
three beeps from the keypad. Identification of each faulted
protection point should appear on the display. The display will
clear when the door or window is closed.
– 27 –
7
2
9
6 then press the TEST key.
(Continued)
Advertisement
Table of Contents
