Using Device Commands - ADEMCO VISTA-20SEA User Manual

USING DEVICE COMMANDS

General Information
Your system may be set up so that certain lights or other devices can be turned on or off by
using the device command from the keypad. Ask your installer if this has been done in your
system. If programmed for your system, some devices may activate automatically upon certain
system conditions. In this case, the following commands can be used to override the device
activation. See your installer for a full explanation of this feature.
To activate devices
ENTER SECURITY CODE THEN PRESS # + 7 + DEVICE NUMBER
(Security Code)
Example: 7
representing the device you wish to activate. See your installer for device numbers assigned
for your system.
To deactivate ENTER SECURITY CODE THEN PRESS # + 8 + DEVICE NUMBER
devices
(Security Code)
Example: 7
representing the device you wish to deactivate. See your installer for device numbers assigned
for your system.
Device
+ # + 7 +
(Device Number)
2 9 6 then press
+ # + 8 +
(Device Number)
2 9 6 then press
Description
1
2
3
4
# , then press
# , then press
Device
5
6
7
8
– 23 –
7 , then enter the number
8 , then enter the number
Description