Combination Switch - Mercedes-Benz 2016 SLK Operator's Manual

Exterior lighting
110
Parking lamps
! If the battery has been excessively dis-
charged, the parking lamps or standing
lamps are automatically switched off to
enable the next engine start. Always park
your vehicle safely and sufficiently lit
according to legal standards. Avoid the
continuous use of the T parking lamps
for several hours. If possible, switch on the
X right or the W left standing lamp.
To switch on: turn the light switch to T.
X
The green T indicator lamp in the instru-
ment cluster lights up.
Standing lamps
Switching on the standing lamps ensures the
corresponding side of the vehicle is illumina-
ted.
To switch on the standing lamps: the
X
SmartKey is not in the ignition lock or it is in
position 0.
Turn the light switch to W (left-hand side
X
of the vehicle) or X (right-hand side of
the vehicle).

Combination switch

Turn signal
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
To indicate briefly: press the combination
X
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
To indicate: press the combination switch
X
beyond the pressure point in the direction
of arrow ; or ?.
High-beam headlamps
To switch on manually: turn the Smart-
X
Key to position 2 in the ignition lock or start
the engine.
Vehicles without Adaptive Highbeam
X
Assist: turn the light switch to L or
Ã.
Vehicles with Adaptive Highbeam Assist:
X
turn the light switch to L.
Press the combination switch beyond the
X
pressure point in the direction of arrow :.
In the à position, the high-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
To deactivate: move the combination
X
switch back to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active, it
automatically controls activation of the high-
beam headlamps ( page 112).
Y
High-beam flasher
To switch on: turn the SmartKey in the
X
ignition lock to position 1 or 2 or start the
engine.
Pull the combination switch in the direction
X
of arrow =.