Clearing The Memory - Mercedes-Benz 2016 SLK Operator's Manual

Table of Contents

Advertisement

operate in the frequency range of 280 to
433 MHz.
Replace the batteries in garage door
R
remote control A. This increases the like-
lihood that garage door remote control A
will transmit a strong and precise signal to
the integrated garage door opener.
When programing, hold remote control A
R
at varying distances and angles from the
button which you are programing. Try vari-
ous angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
If another remote control is available for the
R
same garage door drive, repeat the same
programing steps with this remote control.
Before performing these steps, make sure
that new batteries have been installed in
garage door drive remote control A.
Note that some remote controls only trans-
R
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Press button B on remote control A again
before transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control.
Please also read the operating instructions
for the garage door system.
Turn the SmartKey to position 2 in the igni-
X
tion lock (
page 139).
Y
Press button ;, = or ? which you have
X
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
The transmitter will transmit a signal as
long as the button is pressed. The trans-
mission is halted after a maximum of ten
seconds and indicator lamp : lights up
yellow.
Press button ;, = or ? again if neces-
X
sary.

Clearing the memory

Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
Turn the SmartKey to position 2 in the igni-
X
tion lock (
page 139).
Y
Press and hold buttons ; and ?.
X
The indicator lamp initially lights up yellow
and then green.
Release buttons ; and ?.
X
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
Features
271
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents