Mercedes-Benz 2016 SLK Operator's Manual page 275

Push a round pen into opening
X
=( page 272) for approximately three
Y
seconds.
The zone currently selected appears in
compass display ;(
Y
To select the zone: push a round pen into
X
opening =( page 272) until the desired
Y
zone is selected.
If, after a few seconds, the display in com-
pass display ;( page 272) changes
Y
direction, the zone has been selected.
Calibrating the compass
Make sure that there is sufficient space for
X
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
calibrate the compass in the open and not
R
in the vicinity of steel structures or high-
voltage transmission lines.
switch off electrical consumers such as the
R
climate control, windshield wipers or rear
window defroster.
close all doors and the trunk lid.
R
Switch on the ignition.
X
Push a round pen into opening
X
=( page 272) for approximately six sec-
Y
onds, until symbol C is shown in compass
display ;( page 272).
Y
Drive your vehicle in a full circle at approx-
X
imately 3 mph (5 km/h) to 6 mph
(10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ;(
Floormats
G WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
page 272).
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.
X
X
X
X
X
page 272).
Y
Slide the seat backwards.
To install: place the floormat in the foot-
well.
Press studs : onto retainers ;.
To remove: pull the floormat off retain-
ers ;.
Remove the floormat.
Features
273
Z