Disconnecting; Connecting - Metrologic Voyager MS9500 Series Installation And User Manual

Single-line hand held laser scanner

Hide thumbs Also See for Voyager MS9500 Series:

Table of Contents

NTRODUCTION

Disconnecting the PowerLink Cable

Before removing the cable from the scanner, Metrologic recommends that the

power on the host system is off and the power supply has been disconnected

from the PowerLink cable.

Locate the small 'pin-hole' on the top of the unit near the bottom of the

Voyager logo.

Bend an ordinary paperclip into the shape shown above.

Insert the paperclip (or other small metallic pin) into the small 'pin-hole'.

There will be an audible click when the connector lock releases. Pull gently

on the strain-relief of the PowerLink cable to separate the cable from the

scanner.

Connecting the PowerLink Cable

Important: If the PowerLink cable is not fully latched, the unit can power

intermittently.

Figure 3.

Figure 2.

Figure 4.

Table of Contents