Design Specifications; Operational - Metrologic Voyager MS9500 Series Installation And User Manual

D S
ESIGN PECIFICATIONS
O
PERATIONAL
Light Source
Laser Power:
Depth of Scan Field:
Scan Speed:
Scan Pattern:
Minimum Bar Width:
Infrared Activation:
Decode Capability:
System Interfaces:
Print Contrast:
Number Characters
Read:
Roll, Pitch, Yaw:
Beeper Operation:
Visual Indicators:
Default Settings
* In some custom units, the standard green LED has been replaced with a blue LED
and the red LED has been replaced with a white LED.
Specifications are subject to change without notice.
MS9500 Series Specifications
Visible Laser Diode 650 nm
Less than 1 mW (peak)
0 mm - 203 mm (0" - 8") for
0.330 mm (13 mil) bar code at default settings
72 scan lines per second
Single scan line
0.127 mm (5.0 mil)
Long Range: 0 mm – 279 mm ± 51 mm (0" – 11" ± 2")
Short Range: 0 mm – 102 mm ± 25 mm (0" – 4" ± 1")
Autodiscriminates all standard bar codes for others call
a Metrologic service representative
RS232, PC Keyboard Wedge, Stand-Alone Keyboard,
RS485 IBM 468X/469X, Light Pen Emulation, Laser
Emulation, RS232 with DSR, Low Speed USB (Serial
Emulation or Keyboard Emulation), Full Speed USB
35% minimum reflectance difference
Up to 80 data characters (Maximum number will vary
based on symbology & density)
42°, 68°, 52°
7 tones or no beep
Green* LED
Red* LED
Yellow LED
(MS9540 Only)
laser on, ready to scan
good read
ON, CodeGate button is inactive
OFF, CodeGate button is active
31