Audible Indicators - Metrologic MS6720 Installation And User Manual

Audible Indicators

When the MS6720 scanner is in operation, it provides audible feedback.
These sounds indicate the status of the scan and scanner. Four settings are
available for the tone of the beep. To change the tone, refer to the Program-
ming Guide section: Beeper Tones.
One Beep
*
When the scanner first receives power, both LEDs come on
together along with the beep-the green LED only flashes.
After the scanner performs this startup sequence, the
scanner is ready to scan.
When the scanner successfully reads a bar code, the green light
will flash and beep once (if programmed to do so). If the scanner
does not beep once and the green light does not flash, then the
bar code has not been successfully read.
Razzberry Tone
This tone is a failure indicator. Refer to failure modes page 11.
Three Beeps - after power up
***
When entering the program mode, the green LED will flash
while the scanner simultaneously beeps three times. The green
LED will continue to flash until the unit exits program mode.
Upon exiting program mode, the scanner will beep three times
and the green LED will stop flashing. When configured, 3 beeps
can also indicate a communications timeout during normal
scanning mode.
10