Audible Indicators - Metrologic MS9500 Voyager series Installation And User Manual

A I
UDIBLE NDICATORS
When the Voyager is in operation, it provides audible feedback. These sounds
indicate the status of the scanner. Eight settings are available for the tone of the
beep (normal, 6 alternate tones and no tone). To change the beeper tone, refer
to the MetroSelect Single-Line Configuration Guide or MetroSet2's help files.
* In some custom units the standard green LED has been replaced with a blue LED and
the red LED has been replaced with a white LED.
16
One Beep
When the scanner first receives power, the green* LED will
turn on, then the red* LED will flash and the scanner will
beep once. The red LED will remain on for the duration of
the beep. The scanner is ready to scan.
When the scanner successfully reads a bar code, the red
LED will flash and the scanner beeps once (if configured to
do so). If the scanner does not beep once and the red light
does not flash, then the bar code has not been successfully
read.
Razzberry Tone
This tone is a failure indicator. Refer to "Failure
Modes" on page 18.
Two Beeps – On Power Up
When a Flash ROM upgrade is needed, the scanner will
beep twice followed by alternating flashes of the green and
red LEDs.
Three Beeps - During Operation
When entering configuration mode, the red LED will flash
while the scanner simultaneously beeps three times. The
red and green LEDs will continue to flash while in this
mode. Upon exiting configuration mode, the scanner will
beep three times, and the LEDs will stop flashing.
When configured, 3 beeps can also indicate a
communications timeout during normal scanning mode.
When using one-code-configuration, the scanner will beep
three times (the current selected tone), followed by a short
pause then by a high tone and a low tone. This tells the
user that the single configuration bar code has successfully
configured the scanner.
Three Beeps - On Power Up
This is a failure indicator. Refer to "Failure Modes" on page
18.