System Pin; Ring Priority; First Ring On/Off - Topcom Orbit User Manual

Base settings
8.5

System PIN

The System PIN is used for registering and deregistering handsets and some other
optional settings. The default System PIN is 0000.
8.6

Ring Priority

If you have more then one handset registered, you can choose which handset should ring
first before the others starts to ring. You can also set the amount of rings (2,4 or 6) after
the others start to ring.
8.7

First ring On/Off

If you have Caller ID service, your phone will not ring until the caller information has been
received. You can make your handsets to ring without waiting for the caller information
by turning the first ring On:
32
3 Select "Set Base".
4 Select "Recall Mode".
5 Select "Recall 1" for short flash time (100ms) or "Recall 2" for long
flash time (250ms).
6 Return to standby.
1 Enter the menu.
2 Select "Settings".
3 Select "Set Base".
4 Select "System PIN".
5 Enter the old PIN (0000 by default) and select "OK".
6 Enter the new PIN, select "OK" and repeat this.
7 Return to standby.
1 Enter the menu.
2 Select "Settings".
3 Select "Set Base".
4 Select "Ring Priority".
5 Select "All Handset" or "Select Handset".
If "Select Handset" is selected:
6 Select the handset that should ring first.
7 Set the ring delay to 2, 4 or 6 rings and confirm.
8 Return to standby.
1 Enter the menu.
2 Select "Settings".
3 Select "Set Base".
4 Select "First Ring".
5 Select "On" or "Off" and confirm.
6 Return to standby.