Install Logs And Rock Wool - Vermont Castings 380IDVNVSB Installation And Operating Instructions Manual

380IDV Fireplace Insert
INSTALL LOGS AND ROCK WOOL (EMBER
MATERIAL) IN FIREBOX
Before you begin - This unit is supplied with seven (7)
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
1. Open front door of firebox.
2. Break up rock wool (ember material) into dime-sized
pieces. Place evenly as shown. Do not exceed 1" layer.
Figure 18
3. Carefully remove the seven (7) logs from wrapping.
Figure 18 -
Rockwool Placement
20
Rockwool
Areas
LG765
place rockwool
LG766
rockwool
The positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may re-
sult in property damage or personal injury.
4. Place rear log #1 against back of firebox. Figure 19
Rear Log #1
Figure 19
5. Align holes in the bottom of the left base log #2 with
two (2) pins on the left side of insert. Install left base
log. Figure 20
Left Front Log #2
LG767
Rear log #1
Figure 20
INSERT INSTALLATION
20306756
LG766
rockwool