Epson TM-L500A RFID Technical Reference Manual page 67

Internal parameter settings
Internal parameter settings can be changed with the following:
• ENPC protocol: Epson provides a dedicated utility that makes miscellaneous setting with the
ENPC protocol.
• HTTP browser: An HTTP browser can make setting when connected to the module.
• arp commands and ping commands (Only IP address is settable.):
This function is available only when it has been enabled. The setting can be
made only from a host PC that supports both arp and ping commands and is
in the same segment as the module.
Article Parameters
IP address
Subnet mask
Gateway address
DHCP Enable/Disable
APIPA Enable/Disable
Arp/ping IP setting Enable/Disable
Community name 1 Max. 16
(read-only) characters
Community name 2 Max. 16
(read-write) characters
IP Trap 1 Enable Enable/Disable
IP Trap 2 Enable Enable/Disable
Community name Max. 16
(IP Trap #1) characters
Community name Max. 16
(IP Trap #2) characters
IP trap #1 address
IP trap #2 address
Password
Physical layer Auto negotiation
setting /10Base-T Half
/10Base-T Full
/100Base-TX Half
/100Base-TX Full
Hardware version —
Firmware version —
MAC address —
Utility
Default
values
View
192.168.192.168 Yes
255.255.255.0 Yes
0.0.0.0 Yes
Disable Yes
Disable Yes
Enable Yes
"public" Yes
None Yes
Disable Yes
Disable Yes
None Yes
None Yes
None Yes
None Yes
None No
Auto Yes
negotiation
— Yes
— Yes
— Yes
Browser
Setting View Setting
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
No Yes No
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes No Yes
Yes Yes Yes
No Yes No
No Yes No
No Yes No
Appendix
Status
sheet
print
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
67