Setting the DIP Switches
On this printer, you can make various settings with DIP switches.
Functions of the DIP switches differ depending on the interface.
Setting Procedure
Follow the steps below to change the DIP switch settings.
Before you remove the DIP switch cover, turn the printer off.
Otherwise, a short-circuit may cause the printer to malfunction.
CAUTION
DIP switch settings are enabled only when the power is turned on or the printer is reset via
the interface. If the settings are changed after that, the functions will not change.
1
Make sure the power supply for the printer is turned off.
2
Remove the screw that secures the left case.
3
Slide the left case to the rear to release the groove and two hooks of the
left case, and remove the left case.
Groove
36
Hooks
DIP switches
OFF
ON