Print Density; Print Speed; Lcd Contrast - Epson TM-L500A RFID Technical Reference Manual

Print density

Selectable from levels 1 to 9 (70%  110%) (initial setting: level 7)
 If the print density is set to a darker level, printing speed may be reduced.
 If the print density is set to a darker level, paper dust accumulates on the print head and
 For good print quality, set the print density, depending on the original paper number.

Print speed

Selectable from levels 1 to 10 (Slow  Fast) (initial setting: level 6)
 Depending on print conditions, such as print duty, print head temperature, and data
 For good print quality, set the print speed, depending on the original paper number. (See
User/Context mode
• Single user/Single context (initial setting)
• Single user/Multi context
• Multi user/Multi context
Buzzer volume
Selectable from Off and levels 1 to 5 (initial setting: level 5)
LCD backlight brightness
Selectable from Off, Bright and Dim (initial setting: Bright)

LCD contrast

Selectable from levels 1 to 3 (initial setting: level 3)
48
print may be faint. For information on how to clean the thermal head, see
Thermal Head" on page 59.
(See "Paper Specifications" on page
transmission speed, print speed is automatically adjusted, which may cause white lines
due to intermittent print (the motor sometimes stops). To avoid this, keep the print speed
constant by setting it lower, or set the transmission speed higher for the serial interface.
(See "Transmission Speed (DIP Switches 3/4)" on page
"Paper Specifications" on page
25.)
38.)
25.)
"Cleaning the