Resetting Printer To Factory Defaults; Computer Connections; Usb Interface Requirements - Argox OS-214plus User Manual

Resetting Printer to Factory Defaults

1. Turn on the printer and wait till both "Ready" indicator and
"Power" indicator stay solid green.
2. Press the "Feed" button for 5 seconds, and the "Ready"
indicator and "Power" indicator will go off in order.
(at this step, if the "FEED" button is pressed for 10 seconds,
printer will reset first >> feed blank labels as media
calibration >> and then print configuration/ self-test labels.)
3. Once "Power" indicator becomes lit again, release the
FEED button.
4. "Ready" indicator will then become lit, too. At this moment,
the printer has resumed its factory default settings
Note: Revise the factory default settings that stored in flash,
even if turn off the power source cannot be eliminated.
30

Computer Connections

Note: You must insert the power supply's barrel connector into
the power jack on the back of the printer before
connecting communication cables.
This printer comes with a nine-pin Electronics Industries
Association (EIA) RS-232 serial data interface and a USB
interface. You must supply the required interface cable for your
application.
Note: This printer complies with FCC Rules and Regulations,
Part 15, for Class A Equipment, for use with fully shielded
six-foot data cables. Use of longer cables or unshielded
cables may increase radiated emissions above Class A
limits.

USB Interface Requirements

The Universal Serial Bus (USB) interface is version 2.0 and 1.1
compliant and provides a full-speed (12Mb/s) interface that is
compatible with your existing PC hardware. The USB's "plug and
play" design makes installation easy. Multiple printers can share a
single USB port/hub.
31