Port Mirroring - Interlogix ES2402-24P-2C User Manual

• Duplex
• Pause
• Back Pressure
• Address Learning
• Select Port No.
Buttons
: Click to apply changes

4.3.2 Port Mirroring

Configure port Mirroring on this page. This function provides the monitoring of network traffic that forwards a copy of each
incoming or outgoing packet from one port of a network Switch to another port where the packet can be studied. It enables the
manager to keep close track of switch performance and alter it if necessary.
To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a frame analyzer can be

attached to analyze the frame flow.
The PoE Web Smart Switch can unobtrusively mirror traffic from any port to a monitor port. You can then attach a

10M - Setup 10M Force mode.
100M - Setup 100M Force mode.
1G - Setup 1000M Force mode.
Select any available link duplex for the given switch port. Draw the menu bar to
select the mode.
Full - Force sets Full-Duplex mode.
Half - Force sets Half-Duplex mode.
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used.
Current Rx column indicates whether pause frames on the port are obeyed.
Current Tx column indicates whether pause frames on the port are transmitted.
The Rx and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control.
This setting is related to the setting for Configured Link Speed.
Enable – Start up the flow control.
Disable – Shut down the flow control.
Select the back pressure mode of the Port. Back Pressure mode is used with half
duplex mode to disable ports from receiving messages. Back Pressure mode is
enabled by default. The possible field values are:
Enable – Start up the back pressure mode.
Disable – Shut down the back pressure mode.
Switches remember the source hardware address of each frame received on an
interface, and they enter this information into a MAC database called a
forward/filter table.
Enable - Start up the Address Learning.
Disable – Shut down Address Learning.
Select port number for this check box list.
43