Chapter 7
3) Push the left of the rear cover [1] in the arrow [A] direction to disengage
the claw [2] from the receptacle hole [3].
4) Insert a screwdriver etc into the indicated hole [4] by approx 10mm in the
horizontal direction and push the claw in the arrow [B] direction to disen-
gage the claw [5] from the receptacle hole [6].
Be sure not to tilt or forcibly insert a screwdriver. Failure to do so may
damage the sensor flag on the paper width sensor (PS802).
5) Detach the rear cover [1] in the arrow [C] direction.
Be sure not to forcibly detach the rear cover. Failure to do so may cuts the
grounding wire inside the rear cover.
[C]
[3]
[A]
[2]
6) Free the grounding cable [2] from the cable guide on the rear cover [1].
[1]
[2]
7.2.3 Right Cover
7.2.3.1 Preparation for Detaching the Right Cover
1) Remove the document feed tray and the paper tray cover. (page 7-2)Ref-
erence[Removing the Document Feed Tray and the Paper Tray Cover]
7.2.3.2 Detaching the Right Cover
1) Open the cartridge cover [1] in the direction of the arrow [A].
2) Remove the screw [2].
3) Disengage the 3 claws [3] and open the right cover [4] in the direction of
the arrow [B].
4) Disengage the claw [5] to detach the right cover [4].
7-2
[1]
[4]
[B]
[5]
[6]
F-7-3
F-7-4
7.2.4 Left Cover
7.2.4.1 Preparation for Detaching the Left Cover
1) Remove the document feed tray and the paper tray cover. (page 7-2)Ref-
erence[Removing the Document Feed Tray and the Paper Tray Cover]
7.2.4.2 Detaching the Left Cover
1) Open the cartridge cover [1] in the direction of the arrow [A].
2) Remove the 2 screws [2].
3) Disengage the 3 claws [3] and open the left cover [4] in the direction of
the arrow [B].
4) Disengage the claw [5] to detach the left cover [4].
[2]
7.2.5 External Cover
7.2.5.1 Removing the Document Feed Tray and the Paper
Tray Cover
1) Remove the document feed tray [1] and paper tray cover [2].
0018-3819
0018-3820
[1]
[3]
[A]
[5]
[4]
[3]
[B]
F-7-5
[1]
[A]
[B]
[3]
[4]
[5]
F-7-6
[2]
0018-3821
0018-3822
0018-3818