Air Circuitlation; Moving The Projector; Installing The Projector Properly - Ask Proxima E2465 User Manual

Safety Guide

Air circuitlation

Vents in the cabinet are provided for ventilation.
To ensure reliable operation of the product and
to protect it from overheating, these openings
must not be blocked or covered.
Caution
Hot air is exhausted from the exhaust vent.
When using or installing the projector, the
following precautions should be taken.
- Do not put any flammable objects, or spray
can near the projector. Hot air is exhausted
from the air vents.
- Keep the exhaust vent at least 1 m away from
any objects.
- Do not touch a peripheral part of the exhaust
vent, especially screws and metallic part. This
area will become hot while the projector is
being used.
- Do not put anything on the projector. Objects
put on the cabinet will not only get damaged
but also may cause fire hazard by heat.
Cooling fans are provided to cool down the
projector.
The fan's running speed is changed according
to the temperature inside the projector.
Air Intake Vent
Exhaust Vent

Moving the projector

When moving the projector, cover the lens
cap and retract the adjustable feet to prevent
damage to the lens and cabinet. Put it into a
pouch (provided) with the lens facing upwards
if the projector is not in use for a long period.
6
Air Intake Vent

Installing the projector properly

Be sure to install the projector properly.
Improper installation may reduce the lamp
lifetime and even cause a fire hazard.
Do not roll the projector over 20
degrees from side to side.
Do not point the projector up to
project an image.
Do not point the projector down
to project an image.
Do not put the projector on either
side to project an image.
Caution in ceiling installation the projector
- Only qualified personal is authorized for ceiling
installation.
- We are not responsible for the hurt and
damage caused by ceiling brakect that
purchased from unauthorized dealer even in
warranty period.
- Remove the ceiling bracket immediately while
not use.
- While installing, torque screwdriver is suggested,
don't use electric or impact-type screwdriver.
Torque:1.25+0.2Nm
Caution in moving or transporting the
projector
– Do not drop or bump the projector, otherwise
damages or malfunctions may result.
– When carrying the projector, use a suitable
carrying case.
– Do not transport the projector by courier or
any other transport service in an unsuitable
transport case. This may cause damage
to the projector. For information about
transporting the projector by courier or any
other transport service, consult your dealer.
– Do not put the projector in a case before it is
cooled enough.
M6x10
10mm