Iso Mount Radio Provision With Pocket - Metra Electronics 99-5819 Installation Instructions Manual

ISO MOUNT RADIO PROVISION WITH POCKET

*
Note: Refer also to the instructions included with the aftermarket radio.
1 Cut and remove the top (2) mounting
holes off of the radio housing.
Note: The notch in the housing
should be on top. (Figure A)
2 Slide the included brackets onto the
sides of the radio housings pocket
from the back of the housing
forward. (Figure B)
3 Mount the ISO Brackets to the head
unit with the screws supplied with
the unit. (Figure C)
4 Slide the head unit into the radio
opening until the side clips engage.
(Figure D)
5 Snap the trim plate into the Radio
Housing. (Figure D)
Continue to final assembly.
D
99-5819 KIT ASSEMBLY
A
CUT
B
C
3
CUT HERE -TOP LEG ONLY
CUT HERE -TOP LEG ONLY
CUT