INSTALLATION INSTRUCTIONS FOR PART 99-5721 2010 FORD TAURUS 99-5721 KIT FEATURES • DIN Head unit provisions with pocket • ISO DIN Head unit provision with pocket • DDIN Head unit provisions • ISO Stacked head unit provisions • Painted Silver to match factory fi nish KIT COMPONENTS •...
99-5721 DASH DISASSEMBLY 2010 FORD TAURUS Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip and remove the (2) trim panels on the left and right side of the cup holders and shifter. (Fig. A) Unclip and remove the trim panel to the right of the passenger a/c vent.
Page 4
99-5721 DASH DISASSEMBLY 2010 FORD TAURUS Unclip and remove the gauge cluster trim panel. (Fig. D) Unclip and remove the trim panel/ speaker grill from above the radio trim panel. (Fig. D) Remove (4) Phillips screws from the cup holder trim panel then unclip and remove the panel.
99-5721 DASH DISASSEMBLY 2010 FORD TAURUS Remove (4) Phillips screws from the ash tray trim panel then unclip and remove the ash tray assembly. (Fig. G) Remove (10) phillips screws from the radio trim panel including the a/c vents then unclip and remove the panel.
99-5721 KIT PREPARATION 2010 FORD TAURUS Attach the left and right a/c vent trim panels to the main radio housing panel using the provided (10) #8X3/8” Phillips screws. (Fig. A) Snap the a/c vents and chrome vent trim into the appropriate vent trim panel.
99-5721 KIT ASSEMBLY DIN HEAD UNIT PROVISION Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Fig. A) Snap the pocket into the bottom opening of the radio housing. (Fig. B) Slide the aftermarket head unit into the cage and secure.
99-5721 KIT ASSEMBLY ISO DIN HEAD UNIT PROVISION Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Fig. A) Snap the pocket into the bottom opening of the radio housing. (Fig. B) Slide the head unit into the radio opening until the side clips engage.
99-5721 KIT ASSEMBLY DDIN / STACKED ISO DIN HEAD UNIT PROVISION Cut and remove the center bar from the radio housing. (Fig. A) Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Fig. B)
99-5721 KIT ASSEMBLY CUSTOMIZING THE DISPLAY Changing The Display Back Light Color 1. Press the Passenger Heated Seat button for 10 seconds, the unit will go into “Configure Backlight Color” mode. The display will show “Red Green Blue” with number assigned to each color contributing to the overall back light color while in this mode.
Page 11
99-5721 KIT ASSEMBLY screen will then be displayed and the cursor will appear and blink. It will be located in the 1st location on the top row. 2. To modify the text : A. Use the FAN buttons to move the cursor forward or back. The location where the cursor is blinking is the location that the character may be changed.
Page 12
99-5721 KIT ASSEMBLY Dual Zone Temperature Controls (allows 99-5721 to operate in a dual-zone climate controlled car) 1. Press the Temp Down and Passenger Heated Seat button simultaneously to enter Dual Zone Set Mode. Note: The ZONE icon will light to indicate that you are in dual zone mode, and the temperature bar graph will flash.