Metra Electronics 99-5717 Installation Instructions

5
Fig. A
(located under
the rear deck)
Open the trunk, remove (4) pop-clips from the driver's side trunk liner and remove the liner.
Locate the factory tuner on the wall of the trunk and disconnect the speaker and
(see Fig. A).
antenna plugs (it is NOT necessary to remove the tuner). (see Fig. B).
the unit speaker plug and the antenna extension lead into the unit antenna plug. Slide the
extension harness through the space in the back seat between the seat back and seat bottom.
Unclip the rocker trim, tuck the extension harness under the carpet and stretch the harness to
the back of the dash. (Replace the rocker trim when completed). Splice the speaker leads on
the extension harness into the rear of the aftermarket head unit. Plug the factory wiring
harnesses into the switch connectors (previously mounted in step #2) and audio connectors
on the back of the Integrated Mounting Kit.
6
Re-connect the battery terminal and test the unit, climate controls and rear defroster for proper
operation. Snap the Integrated Mounting Kit
3
rev. 03/08/07
Fig. B
Plug the 70-5715 into
assembly into the sub-dash.
INST99-5717
KIT FEATURES
ISO-DIN
head unit
99-5717
provisions
Incorporates
factory climate
INSTALLATION
controls into
installation
INSTRUCTIONS
Passenger Air Bag
On/Off Light
Incorporated
KIT COMPONENTS
APPLICATIONS
CAR
FORD
Taurus 2004-2007..................................................1-3
MERCURY
Integrated
Sable 2004-2007.....................................................1-3
Mounting Kit
ISO Faceplate
Extension
ISO Brackets
(2) #8 x 3/8"
Phillips Pan-head Screws
TOOLS REQUIRED
86-5618 - Head unit
removal keys
1-800-221-0932
Torx-head screwdriver ©
COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
PAGE
www.metraonline.com