Subaru Impreza 2016 Owner's Manual page 252

6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
opener by pressing the programmed
HomeLink button.
®
Operating the HomeLink
less Control System
Once programmed, the HomeLink
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
®
or call 1-800-355-3515.
R e p r o g r a m m i n g a s i n g l e
HomeLink button
®
1. Press and hold the HomeLink
you wish to reprogram. DO NOT release
the button until step 4 has been com-
pleted.
2. When the HomeLink indicator light
®
begins to flash slowly (after approximately
20 seconds), position the hand-held trans-
mitter of the device between 1 to 3 inches
(25 to 76 mm) away from the HomeLink
button you wish to program.
3. Press and hold the hand-held trans-
mitter button. The HomeLink
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
Wire-
®
The programming for the previous device
Wire-
is now erased and the new device can be
®
operated by pressing the HomeLink
button.
Erasing HomeLink
ory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
erased for security purposes.
button
®
Instruments and controls/Mirrors
®
indicator
®
1) HomeLink
®
2) HomeLink
3) HomeLink
button mem-
®
1. Press and hold the two outer buttons
(button 1 and button 3) until the indicator
light begins to flash (after approximately
20 seconds).
2. Release both buttons.
In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink
buttons be
programming, contact HomeLink
®
www.homelink.com or call 1-800-355-
3515 for assistance.
3-107
button 1
®
button 2
®
button 3
®
button after
®
at
®
CONTINUED