Subaru Impreza 2016 Owner's Manual page 249

3-104
Instruments and controls/Mirrors
including interference that may cause
undesired operation of the device.
NOTE
Le présent appareil est conforme aux
CNR d Industrie Canada applicables
aux appareils radio exempts de licence.
L exploitation est autorisée aux deux
conditions suivantes: (1) l appareil ne
doit pas produire de brouillage, et (2)
l utilisateur de l appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d en compromettre le fonctionnement.
HomeLink and the HomeLink
®
registered trademarks of Johnson Con-
trols, Inc.
WARNING
. W h e n p r o g r a m m i n g t h e
HomeLink Wireless Control Sys-
®
tem, you may be operating a
garage door opener or other
device. Make sure that people
and objects are out of the way
of the garage door or other
device to prevent potential harm
or damage.
. Do not use the HomeLink
less Control System with a gar-
age door opener that lacks the
safety stop and reverse feature
as required by applicable safety
standards. A garage door opener
which cannot detect an object,
signaling the door to stop and
reverse, does not meet these
safety standards. Using a garage
door opener without these fea-
tures increases risk of serious
injury or death. For more infor-
mation, consult the HomeLink
website at www.homelink.com or
call 1-800-355-3515.
house are
®
When programming the HomeLink
Wireless Control System to operate
a garage door opener or an entrance
gate, unplug the device s motor
from the outlet during programming
to prevent motor burnout.
NOTE
. After programming your HomeLink
Wireless Control System for the de-
sired devices, retain the hand-held
transmitters for further programming
Wire-
®
or device testing in the event of a
problem.
. It is recommended that you insert a
new battery in the hand-held transmit-
ter of a device to ensure correct
programming.
NOTE
When programming the HomeLink
Wireless Control System for a garage
door opener, it is suggested that you
®
park the vehicle outside the garage.
1. Unplug the motor of the garage door
opener from the outlet.
CAUTION
NOTE
If any of the HomeLink
®
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
Garage door opener program-
ming in the U.S.A.
buttons are
®
®