Land Pride Accu-Z Razor ZSR54 Service Manual page 9

Section 1: Operator Controls
Deck Lift Removal
Refer to Figure 1-16:
1. Chock wheels to secure mower and prevent
movement while repairs are made.
2. Remove the deck height stop from the height gauge
bar.
3. Place blocks under the mower deck and lower the
deck until the deck is fully supported by the blocks.
Refer to Figure 1-17:
NOTE: Ensure that the deck chains are all slack.
4. Remove the E-clip from the height gauge bar
trunnion that attaches the height gauge bar to the
foot lift peddle and remove the height gauge bar
trunnion from the foot lift peddle.
5. Slide the height gauge bar out of the frame channel.
The height pawl will not need to be removed for
removal of the height gauge bar.
6. Disconnect and remove the deck lift assist spring
from the deck lift pivot.
Refer to Figure 1-18:
7. Remove the E-clips from both the front and rear of
the lift spring assembly trunnions.
NOTE: Springs are under compression against the
frame stop and front jam nut on the lift spring
assembly and care should be taken when
removing.
8. Remove lift spring trunnion from the front deck lift
arm and loosen the nuts and move the trunnion to the
end of the spring rod.
9. Compress the spring assembly back to loosen and
remove the lift spring trunnion from the back deck lift
arm.
10. Allow spring on the lift spring assembly to
uncompress and remove the lift spring assembly
through the slot in the frame stop
7/30/12
Table of Contents
ZSR54 & ZSR60 Accu-Z Razor
Figure 1-16
Figure 1-17
Figure 1-18
®
Zero Turn Mowers 357-388SM
33690
33691
33692
9