Section 8: Maintenance & Lubrication - Land Pride Accu-Z Razor ZSR54 Service Manual

Section 8: Maintenance & Lubrication
Section 8: Maintenance & Lubrication
Maintenance
Regular scheduled maintenance is the best prevention
for costly downtime and expensive, premature repair.
Correct problems as quickly as possible. The following
pages contain suggested maintenance information and
schedules to follow routinely.
Check initially and periodically for loose bolts and pins.
Torque loose bolts per the "Torque Values Chart" on
page 79. Remain alert for unusual noises, they could be
signaling a problem. Visually inspect machine for any
abnormal wear or damage. A good time to detect
potential problems is while performing scheduled
maintenance. Correcting problems as quickly as
possible is the best insurance.
Clear away heavy build-up of grease, oil, and dirt,
especially around the engine and under the seat
platform. Minute dust particles are abrasive to
close-tolerance engines and hydraulic assemblies.
Inspect mower daily for grass clippings, tangled wire and
string. The underside of the mower deck will collect a
build-up of grass clippings and dirt, especially when
grass is wet or has high moisture content. This build-up
will harden, restricting blade and air movement and will
usually produce a poor quality of cutting. Therefore,
debris should be routinely removed from under the deck.
To do this, it will be necessary to raise and block the deck
in the full up position before scrapping build-up from
underneath.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled
personnel. Consult your Land Pride dealer when
assistance is needed.
Maintenance Safety
!
DANGER
Repairs or maintenance specifically requiring engine power
should be performed by trained personnel only. Control levers
should be out. If control levers are to be operated, the tires
should be properly supported off the floor. Enclosed areas
should be properly ventilated to prevent carbon monoxide
poisoning.
!
DANGER
Before working on or under the deck, make certain blade
engagement switch has been shut off, deck has been properly
blocked up, engine has been shut off and ignition switch key
has been removed for maximum safety.
Repairs or maintenance requiring engine power should be
performed by trained personnel only.
54 ZSR54 & ZSR60 Accu-Z Razor
Table of Contents
®
Zero Turn Mowers 357-388SM
!
DANGER
Exercise caution when working under the deck as the mower
cutting blades are extremely sharp. Wearing gloves is
advisable when working around or with cutting blades.
!
WARNING
Read and observe all safety warnings in this manual and in the
engine service manual.
!
WARNING
Except when checking or changing components, always keep
protective shields on for safety as well as for cleanliness.
!
WARNING
Keep your machine clean. Remove all deposits of trash and
clippings. A dirty machine can cause engine fires and
hydraulic overheating as well as excessive belt wear.
!
WARNING
DO NOT have engine running when servicing or making
adjustments to the mower. Shut blade engagement switch off,
move both control levers out, set park brake on, shut engine off
and remove ignition switch key.
!
WARNING
When possible, clean under the deck using a stick or similar
instrument making sure that no part of the body, especially
arms and hands are under the mower.
!
WARNING
Keep mower properly maintained. Do not make unauthorized
modifications. An improperly maintained mower or one that
has been improperly modified can be dangerous to operate.
!
WARNING
Do not operate mower with loose pins, bolts, and nuts. Loose
hardware can result in a serious breakdown causing bodily
injury or death.
7/30/12