Display Assembly - HP 250 G3 Maintenance And Service Manual

Display assembly

This section describes removing the display assembly in its entirety and disassembling all the display
subcomponents.
If you only need to remove the display bezel, webcam/microphone module, or display panel, you do not need
to remove the entire display assembly from the computer. See
panel) on page 43
you remove the entire display assembly from the computer.
Description
Raw display panel
For use in non-touch screen models
For use in touch screen models
Antennas
For use in models without a touch screen (includes wireless antenna cables and transceivers)
For use in touch screen models (includes wireless antenna cables and transceivers)
Display bezel
For use in HP 250 G3 models
For use in HP 256 G3 models (China only)
Display cable
Display enclosure
Touch screen models
Non-touch screen models
Display hinges (left and right)
Models without a touch screen
Models with a touch screen
Webcam/microphone module, HD
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
● Keyboard (see
●
Top cover (see
To remove the display assembly:
72 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
for more information about removing the display subcomponents that do not require that
Battery on page
Keyboard on page
Top cover on page
Display subcomponents (bezel, webcam,
35).
39)
47)
Spare part number
750635-001
774165-001
749638-001
774163-001
749644-001
783998-001
749646-001
774164-001
749641-001
749655-001
774166-001
749654-001