Table of Contents
Advertisement
4. If an expansion enclosure is installed on the system-board tray, remove it (see
5. Align the virtual media key with the connector.
6. Press on the virtual media key until it is firmly seated in the connector and make
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation".
Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in one of the following sections.
1. Install the system-board tray cover (see "Reinstalling the system-board tray
2. Install the system-board tray in the chassis (see "Reinstalling a system-board
3. Connect the cables. For more information, see "Connecting the cables" on page
4. For some devices, run the server Setup utility. For more information, see
Reinstalling the system-board tray cover
Attention:
cover is installed and closed or an expansion enclosure is installed. Do not attempt
to override this protection.
Note: If an expansion enclosure is installed on the system-board tray, the
system-board tray cover is not used.
To reinstall the system-board tray cover, complete the following steps:
1. Lower the cover so that the pins at the rear slide down into the slots at the rear
"Removing an expansion enclosure" on page 29); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
28).
sure that the retention clip engages the virtual media key.
cover") or expansion enclosure (see "Reinstalling an expansion enclosure" on
page 46).
tray in a 2U chassis" on page 47 or "Reinstalling a system-board tray in a 3U
chassis" on page 48).
51.
"Updating the server configuration" on page 51.
You cannot install the system-board tray into the chassis until the
System-board
tray cover
of the system-board tray. Before you close the cover, make sure that all
System-board
tray
Chapter 3. Installing optional devices
45
Advertisement
Table of Contents
