IBM System x iDataPlex dx360 M3 User Manual page 70

56
System x iDataPlex dx360 M3: User's Guide
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI Video Output Standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable legacy thunk support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify
whether to use the static IP address or have DHCP assign the IMM IP
address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
– System Security
Select this choice to view or set the Trusted Platform Module (TPM) options.
- TPM Physical Presence
Select this choice to display the current state of the TPM physical
presence. This must be asserted for TPM commands to succeed.
- Refresh TPM Physical Presence State
Select this choice to refresh the current state of the TPM physical
presence.
- TPM Enabled Status
Select this choice to enable/disable and activate/deactivate state of the
TPM.
- TPM Device
Select this choice to enable/disable the TPM device. This command
requires the TPM physical presence to be asserted.
- TPM State
Select this choice to activate/deactivate the TPM device. This command
requires the TPM physical presence to be asserted.
- TPM Force Clear