Reinstalling A System-Board Tray In A 3U Chassis - IBM System x iDataPlex dx360 M3 User Manual

Reinstalling a system-board tray in a 3U chassis

Note: You must remove the 3U chassis from the iDataPlex rack before you install
the system-board tray (see "Removing a 3U chassis from an iDataPlex rack" on
page 24).
To reinstall a system-board tray in a 3U chassis, complete the following steps:
48
System x iDataPlex dx360 M3: User's Guide
1. Slide the system-board tray into the 3U chassis until it stops.
2. Reconnect the cables that connect the system-board tray and optional adapter
to the 3U chassis.
3. Turn the fan assembly so that the connector aligns correctly with the connector
in the power supply.
4. Insert the fan assembly into the 3U chassis. Firmly press the fan assembly
straight down into the chassis by applying pressure on both fan-assembly
handles simultaneously.
5. Reinstall the retention bracket that secures the fan assembly.