Example Of Programming Auto-Scan; Other Programming Features; Scan - Motorola CP110 UHF User Manual

Example of Programming Auto-Scan

Auto-Scan is the last Programming Mode and
can be set to either ON or OFF on a particular
channel.
To set Auto-Scan to ON:
• Enter Programming Mode and select the desired
channel (see Figure 1: Entering Programming
Mode on page 34).
• Short press the PTT button six times to enter
Auto-Scan Programming Selection Mode. The
radio will signal beeps and will show the current
Auto-Scan setting (please refer to "Reading Auto-
Scan Values" on page 37).
• Short press the SB1 button to toggle ON/OFF the
Auto-Scan feature in the channel. When ON, the
LED Indicator will blink RED once. When OFF,
the LED Indicator will blink ORANGE once.

OTHER PROGRAMMING FEATURES

Scan

Scan allows you to monitor other channels to
detect conversations. When the radio detects a
transmission, it will stop scanning and will stop
on the active channel. This will allow you to
listen and talk to people on that channel without
having to change the channel knob. If there is
talking on Channel 2 during this time, the radio
will stay on Channel 1 and you will not hear
Channel 2. After talking has stopped in
Channel 1, the radio waits for 5 seconds before
resuming scan again.
• To start scanning, press the SB2 button (*). When
the radio detects channel activity, it will stops on
that channel until the activity ends. You can talk
to the person(s) transmitting without having to
switch channels by pressing PTT.
• To stop scanning, short press the SB2 button
again.
41
English