Motorola CP110 UHF User Manual page 41

2. I am trying to program a code value but
the radio would not do it. It rolled over and
took me back to value '0'.
The radio will not allow you to program any
values that are not available in the codes pool.
For example, if you try to program code 128,
the radio would not accept it, as the maximum
value allowed is 122. Check the Codes Charts
section to make sure you are programming a
valid number.
3. I am trying to enter the Programming
Mode but the radio would not do it.
The radio might be locked using the CPS to not
allow Front Panel Programming. To re-enable,
use the CPS.
4. When I was programming I made a
mistake and programmed the wrong
value. How can I erase it or
re-program it?
If you make a mistake while programming a
value you have two choices:
• The radio roll-over (and generates a 'wrap-
around' sound) each time it reaches a maximum
(9) or minimum (0) value. Keep increasing (short
press SB1) or decreasing (short pressing SB2)
until you get the desired value or,
• Turn OFF the radio and start-over.
5. I just programmed the value I wanted.
How do I exit Programming Mode?
• If you are in Programming Mode you can exit by
long pressing the PTT button twice.
• If you are already in the 'Idle' Programming
Mode, long press the PTT button once.
39
English