6.
I am done programming the features in
this channel and want to program another
channel.
Switch to the new channel you wish to program
by using the Channel Selector Knob. The radio
will enter 'Idle' Programming Mode. If you wish to
save the changes, make sure you are in the 'Idle'
Programming Mode before switching the channel
as otherwise you will lose the changes made.
PROGRAMMING VALUES EXAMPLES
Example of Programming a Code
Assuming current code value is set to factory
default '001', and you want to change it to
CTCSS/DPL Code = 103 follow the sequence
below:
•
Enter Programming Mode
•
Short press the PTT button three times (Enter
CTCSS/DPL Programming Selection Mode). The
LED Indicator will blink orange to indicate that
current value is '0'.
40
English
•
Press the SB1 button once (to change first digit to
'1') LED Indicator will blink red. Short press the
PTT button (to move forward and program
second digit). The LED Indicator will blink orange
to indicate current value is '0'.
•
Short press the PTT button and move ahead to
program the third digit. LED Indicator will blink
red to indicate current value is '1'.
•
Press the SB1 button to change the 'third digit'
to '2'. Press the SB1 button to change again this
'third digit' to '3'. Radio will signal the chosen
value.
•
Long press the PTT button to save changes and
return to 'Idle' Programming Mode.
•
Once in 'Idle' Programming Mode, LED Indicator
will start blinking a green heartbeat.
•
Long press the PTT button to exit Programming
Mode.