Reading Auto-Scan Values; Programming Frequencies, Codes And Auto-Scan - Motorola RDV2020 - RDX VHF - Radio User Manual

Reading Auto-Scan Values

After reading the CTCSS/DPL codes, short
press the PTT button and the radio will take
you to Auto-Scan (refer to Stage 3 of Figure 3:
Entering Programming Mode on page 40).
Auto-Scan only has two values:
If the radio signals
the value...
0
1
• Auto-Scan is set to OFF by default.
Note: While in Auto-Scan Mode, if you short press
PTT button, the radio will return to the 'Idle'
Programming Mode. It will then generate a
'roll-over' chirp and it will start blinking a
green heartbeat
It means Auto-
Scan is...
OFF
ON
Programming Frequencies, Codes and
Auto-Scan
Each time your radio signals and beeps the
current setting you can change this setting by
either increasing it by short pressing SB1 or
decreasing it by short pressing SB2 . The
radio will then signal the new setting it has
been programmed.
Saving Settings
If you are satisfied with the setting, you can
either:
• short press PTT to continue programming,
• long press PTT to save and return to 'Idle'
Programming Mode, or
• long press the PTT button twice to exit 'Idle'
Programming Mode and return to the normal
radio operation.
Note:
• If you do not wish to save the value you just
programmed, turn radio OFF or change channel
using the channel knob.
41
English