Reading Auto-Scan Values; Programming Frequencies, Codes; Auto-Scan An Active Channels - Motorola RMV2080 User Manual

Reading Auto-Scan Values

After hearing the CTCSS/DPL codes, short
press the PTT button and the radio will take
you to Auto-Scan
Auto-Scan only has two values:
If the radio signals
the value...
0
1
• Auto-Scan is set to OFF by default.
Note:
While in Auto-Scan Mode, if you short press
PTT button, the radio will jump to "Active
Channels" feature, so you can modify the
amount channels available using SB1 and
SB2 buttons.
It means Auto-
Scan is...
OFF
ON

Programming Frequencies, Codes,

Auto-Scan and Active Channels
Each time your radio announces the current
setting you can change this setting by either
increasing it by short pressing SB1 or
decreasing it by short pressing SB2 . The
radio will then announce the new setting it
has been programmed.
Saving Settings
If you are satisfied with the setting, you can
either:
• short press PTT to continue programming,
• long press PTT to save and return to 'Idle'
Programming Mode, or
• long press the PTT button twice to exit 'Idle'
Programming Mode and return to the normal
radio operation.
Note:
• If you do not wish to save the value you just
programmed, turn radio OFF.
41
English