Programming Values Example; Frequency - Motorola RMU2080 User Manual

4.
When I was programming I made a
mistake and programmed the wrong
value. How can I erase it or re-program
it?
If you make a mistake while programming a
value you have two choices:
The radio settings will roll-over each time
•
they reach a maximum or minimum value.
Keep increasing (short press SB1) or
decreasing (short pressing SB2) until you get
the desired value or,
•
Turn OFF the radio and start-over.
5.
I just programmed the value I wanted.
How do I exit Programming Mode?
• If you are in Programming Mode you can exit
by long pressing the PTT button twice.
If you are already in the 'Idle' Programming
•
Mode, long press the PTT button once.
6.
I am done programming the features in
this channel and want to program another
channel.
Press short PTT several times until you hear
"Channel #", then switch channel using
Channel Selector Knob. If you wish to save
the changes, make sure you are in the 'Idle'
Programming Mode before switching the
channel as otherwise you will lose the changes
made.

PROGRAMMING VALUES EXAMPLE

Example of Programming a Frequency
Assuming current frequency value is set to
Channel 1, with the UHF default frequency
'02' (equivalent to 464.5500 MHz), and you
want to change it to Frequency Number =
'13' (which is mapped to 461.1375 MHz), follow
this sequence:
• Enter into Advanced Configuration Mode
43
English