Programming Values Example; Example Of Programming A Frequency; Example Of Programming A Code - Motorola RVA50UL User Manual

PROGRAMMING VALUES EXAMPLE

Example of Programming a Frequency

Assuming current frequency value is set to
Channel 1, with the UHF default frequency set
to '02' (equivalent to 464.5500 MHz), and you
want to change it to Frequency Number = '13'
(which is mapped to 461.1375 MHz), follow this
sequence:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button to enter Frequency
Mode. The radio audible voice announces that
the current value is '2'.
3. Press the SB1 button eleven times to increase
frequencies and you will hear frequency "One,
three" (13).
4. Long press the PTT button. LED Indicator
shows a green heartbeat to indicate 'Idle'
Programming Mode.
5. Long press the PTT button again to exit
Programming Mode or turn OFF the radio.
36
English

Example of Programming a Code

Assuming the current code value is set to
factory default '001', and you want to change it
to CTCSS/DPL Code = 103. Follow the
sequence indicated below:
1. Enter Advanced Configuration Mode.
2. Short press the PTT button twice. The radio
audible voice announced "Code Number"
(Entering CTCSS/DPL Programming Selection
Mode).
3. Pressing and holding SB1 or SB2 button fast
forwards / rewinds the value at the nearest 10's.
When released, the radio audible voice
announces the first, second and third digit in
full. Keep pressing the SB1 or SB2 button
several times until you hear "103".
4. Long press the PTT button. LED Indicator
shows a green heartbeat to indicate 'Idle'
Programming Mode.
5. Long press the PTT button again to exit
Programming Mode or turn OFF the radio.