Table of Contents
Advertisement
Toggled
A toggled switch is one that maintains its state after it is pressed. So, if
the switch is currently in the "off " state, pressing it once will put it in
the "on" state. Pressing it again will put it back in the "off " state.
Pressing both Value buttons simultaneously will set this parameter to Toggled.
Destination
The Destination parameter determines the Controller Destination for the currently selected
controller in the currently selected Zone. For a list of the Setup Destination Controllers and
their descriptions, see Destination on page 8-12.
On Value
The On Value is the MIDI value sent when the switch is set to On. You can set this
parameter to any number between 0 and 127, or to None. Pressing both Value buttons
simultaneously will set this parameter to 127.
Off Value
The Off Value is the MIDI value sent when the switch is set to Off. You can set this
parameter to any number between 0 and 127, or to None. Pressing both Value buttons
simultaneously will set this parameter to 0.
Entry State
The Entry State parameter determines the state of the Foot Switch that is sent as a MIDI
message when the current Setup is loaded. You can set this parameter to None, On, or Off.
Pressing both Value buttons simultaneously will set this parameter to None. None is -1.
If Entry State is set to None, then when you load the current Setup, the Foot Switch will be
at whatever value corresponds to its current position. If you specify an Entry State, then a
MIDI controller message with this value will be sent when you load the current Setup.
Exit State
The Exit State parameter determines the state of the Foot Switch that is sent as a MIDI
message when the current Setup is exited. You can set this parameter to None, On, or Off.
Pressing both Value buttons simultaneously will set this parameter to None. None is -1.
If Exit State is set to None, then when you close the current Setup, the Foot Switch will be
at whatever value corresponds to its current position. If you specify an Exit State, then a
MIDI controller message with this value will be sent when you close the current Setup.
Edit Setup Mode
The Zone-specific Parameters
8-15
Advertisement
Table of Contents
