Table of Contents
Advertisement
2. Press the Layer Function button. This creates a Setup with two active Zones with
the same keyboard regions—i.e., overlapping keyboard regions. In this case, Program
125 Real Vibes as the Primary Voice. The Secondary Voice will be the last used Layer
Program or the default Program (ID number 634 Add a Pad 2) if this is the first time
your using the Layer Function since power-up.
Note that as soon as we press the Layer Function button, the display shows the
Secondary Voice and the Save button illuminates. This simply indicates that a change
has been made. The Save button will be involved in the final step of this process.
3. Let's now change the Layer Program. Recall that the Layer Program determines the
Program for the Secondary Voice. The figure below shows the default Program as the
Secondary Voice:
125 Real Vibes
Secondary Voice
634 Add a
Pad 2*
Secondary Voice
(*Default or last used Program)
4. Use the Alpha Wheel the Value buttons, or the alphanumeric data entry buttons (see
the Note on page 11-2.) to select the Secondary Voice. For our example, let's choose
Program 423 Solo Flute for the Layer Program. The following figure illustrates our
current Layer Setup:
125 Real Vibes
Secondary Voice
423 Solo Flute
Secondary Voice
5. Let's now change the Layer Volume. Recall that the Layer Volume determines
the relative volumes of the two Voices: positive values increase the volume of the
Secondary Voice and decrease the volume of the Primary Voice. Negative values
decrease the volume of the Secondary Voice and increase the volume of the Primary
Voice.
First, use the Chan / Param buttons to select the Layer Volume parameter. Then, use
the Value buttons to set the Layer Volume. For our example, since we want our vibes
to be slightly louder than our flute, let's set this parameter to -20.
Creating a Setup from a Program
Tutorials
11-5
Advertisement
Table of Contents
