Planet ICS-100 User Manual page 46

The ICS-10x's "telnet server mode"--if the user used the MS-DOS telnet command it will
show double character. So the user can use other Telnet software like: "putty" or "NetTerm".
Example 1: Telnet Command in Windows Platform
Setup Operation Mode and Serial Port of ICS-10x
1. Set the ICS-10x mode to "Telnet server mode" from web interface.
2. Set the Serial Port Configuration of ICS-10x as below:
Mode:
Baudrare:
Character Bits:
Parity Type :
Stop Bit :
Hardware Flow Control:
Execute "Telnet" command from Windows Start Menu
3. Click the Start Menu and go to Run
4. Type "telnet" without the quotes, and hit enter.
Figure 4-39 Example Telnet Server
RS-232
9600
8
none
1
none
-41-
User's Manual of ICS-10x