Table of Contents
Advertisement
1.
Slide a case utility tool into a space between the base enclosure and the frame of the computer,
exerting gentle pressure until the clips release (1).
2.
Tilt the base enclosure up at the front of the computer (2).
3.
Slide the base enclosure toward the rear of the computer (3).
4.
Lift and remove the base enclosure from the computer (4).
Reverse this procedure to install the base enclosure.
Hard drive
Description
2 TB, 5400 rpm, 9.5mm
1 TB, 5400 rpm, 9.5mm
750 GB, 5400 rpm, 9.5mm
500 GB, 5400 rpm, 7mm/9.5mm
1 TB, 5400 rpm + 8 GB NAND Hybrid HDD, 9.5mm
Hard Drive Hardware Kit (not illustrated, includes the hard drive bracket, connector cable, isolators, and
screws)
IMPORTANT:
and replacement.
Before removing the hard drive, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Base enclosure (see
Remove the hard drive:
Make special note of each screw and screw lock size and location during removal
Battery on page
Optical drive on page
Base enclosure on page
29), and then remove the following components:
30).
33).
Component replacement procedures
Spare part number
801808-005
778192-005
778190-005
778188-005
731999-005
806751-001
35
Advertisement
Table of Contents
