Mercedes-Benz S 4300 Operator's Manual page 364

Mercedes-benz automobile operator's manual

Table of Contents

1 Jack support tube cover

Move cover 1 toward rear by pressing

at point indicated by arrow.

Remove cover 1 carefully to avoid

damage to the locking tabs.

1 Jack support tube hole

Insert jack arm 2 fully into tube

hole 1 up to the stop.

Insert the jack arm fully into the jack sup-

port tube hole up to the stop. Otherwise the

vehicle may fall from the jack and cause per-

sonal injury or damage to the vehicle.

Practical hints

Keeping jack in this position, turn

crank 3 clockwise until the jack base

meets the ground. Make sure the jack

is vertical (plumb line).

Continue to turn the crank until the tire

is a maximum of 1.2 in (3 cm) from the

The jack is intended only for lifting the vehi-

cle briefly for wheel changes. It is not suited

for performing maintenance work under the

Never start the engine when the vehicle

Never lie down under the raised vehicle.