Table of Contents
Advertisement
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.
Step 5:
When the indicator lamp 1 flashes
rapidly, release both buttons.
Step 6:
Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp 1.
If the indicator lamp 1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.
i
If the indicator lamp 1 flashes rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the "rolling code feature".
Step 7:
To program the remaining two buttons,
repeat the steps above starting with
step 3.
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the "Programming" portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Controls in detail
Useful features
Step 8:
Locate "training" button on the garage
door opener motor head unit.
Exact location and color of the button
may vary by garage door opener brand.
Depending on manufacturer, the "train-
ing" button may also be referred to as
"learn" or "smart" button. If there is dif-
ficulty locating the transmitting button,
refer to the garage door opener opera-
tor's manual.
Step 9:
Press "training" button on the garage
door opener motor head unit.
The "training light" is activated.
You have 30 seconds to initiate the follow-
ing step.
Step 10:
Firmly press, hold for two seconds and
release the programmed integrated
signal transmitter button (2, 3
or 4).
253
Advertisement
Table of Contents
