Table of Contents
Advertisement
Memory function
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach, and com-
fort. The head restraint should also be
adjusted for proper height. See also the
section on airbags ( page 59) for
proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the inside and
outside rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213
and 210.2.
You can store up to three different settings
per SmartKey or SmartKey with
KEYLESS-GO*.
The following settings are saved for each
stored position:
Seat and backrest position
Settings for the multicontour seat*
Steering wheel position
Exterior rear view mirror position
Automatic climate control
These key-dependent memory settings
can be deactivated if desired
( page 160).
Warning!
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
Controls in detail
Memory function
The memory button and stored position
switch are located on the door.
1 Stored position buttons
2 Memory button
Make sure the ignition is switched on
or the relevant door is open and the
SmartKey is inserted in the starter
G
switch.
121
Advertisement
Table of Contents
